Driver figure needed

[RazorJon]

I am looking for a 1/24 scale full driver figure for my new build
Something from the 60s

[RazorJon]

How big was that?
I have a driver from immense miniatures
And it won't fit but mine is more a Indy driver as he is laying down

[mattb]

what kind of car? Does it have a full cockpit?

[chappy]

Jon I think I may have an old 1/24 cox driver , peak helmet.
Bob

[RazorJon]

[munter]

I have some resin drivers I am trying to get rid of.
Type one is a Fujimi driver....separate arms and separate full face helmet....X 5
Type two is the Cox GT40 driver....separate head and open face helmet...X 5

Make me an offer I cannot refuse.......pleeease.
Be aware that shipping will cost me ten US dollars.

Pictures if needed

[RazorJon]

are they 1\25 scale?

[mattb]

I can make a 1/24 Cox Chaparral driver or the originals are available from Herman Steinman. For the interior...I recently made a couple molds of the Cox Gurney interior and sent them to Bruce Paterson. He is going to vac form some of those interiors. They will be light weight, have a full front seat and use a model car dash. Cox used the Chap driver in those interiors and they fit the dash and steering wheel perfect. This whole setup was engineered by Cox. Bruce might be a month or so from having this done, but if you can wait, this combo allows a full interior and it is lightweight. I have built stockers with resin Gurney interiors, but that adds a lot of weight, the vac form piece should eliminate the weight and it will fit most full size cars.

[munter]

[mattb]

Chaparral driver looks much better then the Ford GT driver and is more laid down.

[munter]

Fujimi drivers hand are all good with fingers and thumbs intact, Cox are a little murky.
Now I look the Fujimi size is fine once the arms add to the shoulder width.

[RazorJon]

those are nice Munter thx for all the help but I think I will just chop up the guy I have

[munter]

No problem when you are RazorJon...

I will offer them elsewhere...anyone?