Slot Car Corner '73 IROC Proxy - Builds & Usual Chatter

[TuscoTodd]

WhooHoo! That body is shaping up NICE Dave!

The whole kit set up definitely fits the IROC flavor - and I am in! So here is my official "Yes, one kit for me please"

Thank you to everyone that has helped put this together - I think this is going to be great!

Oh - and hopefully I will be able to share what the "new" t-shirts look like later today!
(now just need to get ready to order up the posters and kit!) :D

[JESIV]

1 kit for me please.

[sadco racing]

Yes, one kit for me please

Thx, Steve

[SRQSloter]

Will send Thompson a couple :twocents-mytwocents: just need a paypal address. It may be in this thread but, be like finding a needle in haystack. :lol:

[studioRS]

Rusty, thank you very much! I'd prefer to keep my email off the forum (silly search engines) and will PM you all the details. This is the first Proxy I've ever done and I would like to help out on any others too even if they have already started (think T-Shirts, posters, decals). This will expand my race car graphics portfolio at the same time! Just let me know.

[SRQSloter]

[Fumey]

Did you find anyone to do the glass ?

[Fumey]

And as SRQ mentioned earlier , will we be able to take that slop out of the front axle if we all use the same method ?

[studioRS]

[TuscoTodd]

Lookin' Awesome Dave!
:handgestures-thumbup: :handgestures-thumbup:

[studioRS]

A Californian stuck in Vermont says, "OMG, that is so totally b!tchen dude" :drool: Way kewl.

[HomeRacingWorld]

Way to go. You are working hard on this and looks like a winner so far.

[TuscoTodd]

Received my t-shirts today and the art work looks great! :)

Thompson thank you for making these available - I will be wearing this to the commercial track with pride!!!!

:banana-dance: :banana-dance: :banana-dance: :banana-dance: :banana-dance: :banana-dance: :banana-dance:

[Fumey]

Kit me! :dance:
For the front axle fix , how about this ? - http://www.homeracingworld.com/mrrctuning.htm
or this ? - http://homeracingworld.us/viewtopic.php?f=17&t=5985

[studioRS]

@nhdungeonracer - your PM isn't playing nice and return receipts are turned off, so posting here.

NOTE: As the self-appointed chief HRW Porsche scale police captain, the rear Fuchs are 11" on the real deal RSR have a huge deep offset with a step. How in the heck do we make the CB Design wheel inserts "look" like the real deal Fuchs with the round step down towards the edge? Can we glue in a plastic insert and sand down the edge to replicate? Or forgetta'bout it and just run the resin Fuchs and the HRW-PSP captain goes back to a desk job? :violence-smack:

David sent me a few photos a while back when I needed measurements to design the decals.

The outside rear flares are sitting at 62mm and some change.

Hope these help.