Corvette Build is On...

[SRQSloter]

I don't know about the foil. Would be really ticked off if I went to readjust it and peeled the paint. And if it had a wrinkle in it wouldn't be happy either. Rather take my chances painting it.

[SRQSloter]

I think it's about ready for clear. After stripping and doing it over again from screwing up painting the trim on the side. Decided to leave it off. And dug out the 3/0 brush and do the grill and tail lights by hand. Hot glue the roll bar in tomorrow and clear it. Then the next issue is cutting down the windshield and getting it mounted. Then finish assembling it this weekend. Got a couple little flaws I hope don't show up to bad after clear coat.









:handgestures-thumbup:

[dreinecke]

That looks great!!!

[SRQSloter]

Thanks David! Taken a while to get this one done. Next on the bench will be your T/A Cuda. :banana-dance:

[Ember]

Looking super cool. No longer Batmobilish. ;) Decided on paint for the wheels?

[SRQSloter]

Thanks Ember! I think I'm going to see hot it looks with the aluminum wheels before i spray them black. Thinking may look better.


:handgestures-thumbup:

[waaytoomuchintothis]

Looking great so far, that's for sure.

[HRWJim]

I like it a lot. Very finish on the paint. Jim

[Ember]

Red wheels would be the go. Make it go faster too.

[SRQSloter]

[SRQSloter]

Thanks Jeremy! I've seen a few of these and think for the most part they've been black too. :)

[SRQSloter]

[SRQSloter]

Body is mounted. Waiting on JBW to set up to remove screws and finish assembly. Looks like the wheels will not be getting painted.







:handgestures-thumbup:

[whitworthnut]

Wicked looking car. Nicely done.

[waaytoomuchintothis]

If it runs half as good as it looks, its a winner!