Page 1 of 1
3D printed Lola T260
Posted:
Thu Jun 06, 2019 9:21 pmby racer1h
Latest 3D printed slot car.....always wished they made this in 1/32 (slot it sidewinder pod)....another nimrod file.
Re: 3D printed Lola T260
Posted:
Thu Jun 06, 2019 9:42 pmby slothead
Nice car. How is the wing mounted so it can survive contact or a rollover?
The CG Slotcars Shadow DN4 has a rubber brace holding it in place that can flex with contact and then spring back into position. Of course, the Shadow is such a low profile car I've never even come close to rolling it.
Re: 3D printed Lola T260
Posted:
Fri Jun 07, 2019 5:31 amby FC47
Well that was quick eh?
Came out nice!
Re: 3D printed Lola T260
Posted:
Fri Jun 07, 2019 6:32 amby racer1h
Wing is just glued on with a bit of epoxy. Rubber supports would be nice. Just glue it back on like the slot it group c cars etc.
Re: 3D printed Lola T260
Posted:
Fri Jun 07, 2019 6:52 amby -Nimrod-
Great work again Mate
Your a Machine pumping them out
Cheers
NiMROD