Home Racing World

Hey guys I'm going to give brass chassis a try but would love if you all could post some picks of your stuff for me. Being a visual person I need to look at stuff. So feel free to share it and I'm sure others will enjoy seeing it too. Thanks all!

Awesome. Thanks Harry. Where do you get the razor jig. Razorjon?

Also where do you get the rear assembly that the motor so attached to?

That particular forged brass motor bracket is available from Professor Motor, SCC, & other shops.

If you go to Harry's link above you can also find this one at about 1/2 the price. I'm not sure why the price discrepancy as they seem to be the same.

http://www.amazon.com/Eurotool-Honeycom ... LZ81PN5OB0

If you search on this forum for "honeycomb", you will find my tutorial and lots of other postings about using these blocks. To me the benefit of it is that you can set out the whole chassis and pin it in place and then solder it all at once. It also works well to use a pod such as Slot.it or Devis3d Design and build around it.

Happy building,

Keith

Great start so far. Thanks guys!!!!

Thanks slotter! Ya I'm running 1/32.

I've discovered the fun is very much in the building.

My most recent attempt underway. Number 3 and by far the most succesful yet.

Looks good, Ember. Was it your most successful because you built it on the honeycomb? Works well, eh?

Thanks guys. These will help big time!!¡