Home Racing World

Some time back I did these three types in resin.
Not easy to get a good result but they are light and could be helpful in a build of a CanAm car of some type.





Oh I see a fault and a blur in one pic....early morning fuzziness, sorry.

those look nice

Those must be a bear to get out of the mold! Very well done.

Hi John, The middle set in your first pic., appears to be from the the Rev.Mono MK6 ??....if so, I would love a copy or two.

Please let me know, and we can arrange something.

Cheers
Chris Walker

now why did you not show me them last night when I was around at your place
I would be keen on the middle one in first pick

+1 on that middle set of McLaren M6 injectors~! I see a set in my future !

I have a La Cocaracha which had the stacks cut out to make room for the motor to cool.
Do you have a set of stacks which will fit?

Hello Frank. Can you measure the exact dimension of the hole to fill?

red73mustang....I am working on a package to the US with some of these so a bit of wait is involved.

Munter,
My La Cocaracha has a hole 4cm x 2.5cm.
Some of the motors got a little how back in the day. This is a car that I was given so I can't tell the whole story. All I can tell you is that this is an original not a replica. REH sells the remakes.
I want to put it back into operation. The Track in Gaithersburg, MD will be the place to test it out.

The middle one has dirt modified written all over it......

@Frank9129 the larger two sets of stacks I have, use a smaller base than the hole you describe. A plastic base plate and then the stack set would have to be put together and stuck in if you wanted to use either of them.

@padirtfan...I think you are right but they would also suit a few early CanAm cars too.

Munter,
Drop me a PM as to how much I owe you for a set of stacks. I'll build up the bottom first.
My address is : 283 Hillsmere Drive Annapolis, MD 21403 to calculate the postage.

I think a set of those would be awesome for a gasser drag car!