Home Racing World

I am looking for a 1/24 scale full driver figure for my new build
Something from the 60s

How big was that?
I have a driver from immense miniatures
And it won't fit but mine is more a Indy driver as he is laying down

what kind of car? Does it have a full cockpit?

Jon I think I may have an old 1/24 cox driver , peak helmet.
Bob

I have some resin drivers I am trying to get rid of.
Type one is a Fujimi driver....separate arms and separate full face helmet....X 5
Type two is the Cox GT40 driver....separate head and open face helmet...X 5

Make me an offer I cannot refuse.......pleeease.
Be aware that shipping will cost me ten US dollars.

Pictures if needed

are they 1\25 scale?

I can make a 1/24 Cox Chaparral driver or the originals are available from Herman Steinman. For the interior...I recently made a couple molds of the Cox Gurney interior and sent them to Bruce Paterson. He is going to vac form some of those interiors. They will be light weight, have a full front seat and use a model car dash. Cox used the Chap driver in those interiors and they fit the dash and steering wheel perfect. This whole setup was engineered by Cox. Bruce might be a month or so from having this done, but if you can wait, this combo allows a full interior and it is lightweight. I have built stockers with resin Gurney interiors, but that adds a lot of weight, the vac form piece should eliminate the weight and it will fit most full size cars.

Chaparral driver looks much better then the Ford GT driver and is more laid down.

Fujimi drivers hand are all good with fingers and thumbs intact, Cox are a little murky.
Now I look the Fujimi size is fine once the arms add to the shoulder width.

those are nice Munter thx for all the help but I think I will just chop up the guy I have

No problem when you are RazorJon...

I will offer them elsewhere...anyone?