Wheel/Tire/Razor Video Page
Posted: Sat Mar 05, 2016 8:59 amGreat videos. How bout adding one more? How do you cut the wheel to the proper depth once sized? That's my main problem.
Dave
Home Racing World
Your Slot Car Home On the Net!
http://www.homeracingworld.us/
Wheel/Tire/Razor Video Page
Page 1 of 1
Posted: Sat Mar 05, 2016 8:59 amRe: Wheel/Tire/Razor Video Page
Posted: Sat Mar 05, 2016 9:49 amRe: Wheel/Tire/Razor Video Page
Posted: Sat Mar 05, 2016 9:58 amWell, you will have the measure each wheel.
This is a Fly Classic wheel sized for the 15x10 CB Design. I measure the depth of the wheel, then that dictates my cut. I always cut a little proud and then hand sand the insert on a flat section of sandpaper to set it just right.
This is another example. Scaley MGB.
Not sure if this helps or not. Getting a digital caliper with depth gauge is a great tool. Lowe's has small ones for about 20 bucks.
This is a Fly Classic wheel sized for the 15x10 CB Design. I measure the depth of the wheel, then that dictates my cut. I always cut a little proud and then hand sand the insert on a flat section of sandpaper to set it just right.
This is another example. Scaley MGB.
Not sure if this helps or not. Getting a digital caliper with depth gauge is a great tool. Lowe's has small ones for about 20 bucks.
Re: Wheel/Tire/Razor Video Page
Posted: Sat Mar 05, 2016 12:32 pmThese are great vids....thanks Harry...everything in one place!!!
Re: Wheel/Tire/Razor Video Page
Posted: Sat Mar 05, 2016 1:50 pmSuper easy, great show me videos
Re: Wheel/Tire/Razor Video Page
Posted: Sat Mar 05, 2016 4:36 pmVery nice Harry, great info right here, thx for all the help
Re: Wheel/Tire/Razor Video Page
Posted: Sun Mar 06, 2016 1:18 pmThx for the response Harry but my wording was off. How and what do you use to cut the wheel in half?
Dave
Dave
Re: Wheel/Tire/Razor Video Page
Posted: Sun Mar 06, 2016 2:17 pmRe: Wheel/Tire/Razor Video Page
Posted: Sun Mar 06, 2016 7:46 pmGood articles Harry.
I did notice when watching the videos, that a bunch of others pop up after one finshes.
I think it was in the 2nd video, and after it was over, up popped another video from
down under, it was a pretty good one of using Jons Wheel lathe accessory.
I found it particularly helpful since I just got mine in the mail about a week ago.
Thanks again for the great posts.
Bob
I did notice when watching the videos, that a bunch of others pop up after one finshes.
I think it was in the 2nd video, and after it was over, up popped another video from
down under, it was a pretty good one of using Jons Wheel lathe accessory.
I found it particularly helpful since I just got mine in the mail about a week ago.
Thanks again for the great posts.
Bob