Home Racing World

Posted: **Tue Feb 23, 2016 11:15 am**

My R/M E type has always run rough, while tuning it I noticed that the drive shaft bushing is an incomplete molding. Will a regular brass axle bushing fit? The drive shaft seems a bit thin.

Posted: **Tue Feb 23, 2016 11:41 am**

Motor shafts are usually thinner than axles so the bushing won't fit. I have a bushing from an R/M Daytona Cobra, and you can have it if you send me your address.

Keith

Posted: **Tue Feb 23, 2016 12:15 pm**

You have a P M.

Posted: **Tue Feb 23, 2016 4:35 pm**

It didn't come through if the PM was to me.

Keith

Posted: **Tue Feb 23, 2016 9:43 pm**

OK will try again

Home Racing World

R/M drive shaft bushing

R/M drive shaft bushing

Re: R/M drive shaft bushing

Re: R/M drive shaft bushing

Re: R/M drive shaft bushing

Re: R/M drive shaft bushing