Hi Folks;
I am converting some of my Scalextric cars to Carrera digital. I know its best to take off the components under the heat shrink on the braid wires and run wires direct from chip to braids, but what exactly is on the motor? It looks like the motor wires and rear lighting wires go through what looks like a resistor or maybe a capacitor... What does it do, and is it needed? Can I just run the light wires and the motor wires direct to the chip without using these components?
Note that I do not intend to run theses converted cars on Scalextric track at any point...
Cheers;
Eric