It's back! The 2020 SCCA Proxy rules and reg thread!!!

[chrisguyw]

Electric Dreams also list the Policar motor as "in stock",

Cheers
Chris Walker

[cj74]

Just added the Policar motor (PMX01) to my cart at Cloverleaf. Inventory is low, but they have a few.

[Doubl-B]

Thanks guys! I couldn't find the motors on Cloverleaf searching on "policar" but I'll look again with the motor nbr.
BB

[Mseitz]

I would like to reserve #61. Going to try getting an old Monogram 350gt ‘65 Jerry Titus Mustang body up to speed. Production class.
Mcseitz

[Austin]

old Monogram 350gt ‘65 Jerry Titus Mustang body

Wow I can't wait to see your car.

[docdoom]

Well these sucks. get home to find my 3d chassis showed up, was all set up to try install a inline pod with a 18k motor into that 3d chassis for a Monogram gto-250 . just to find that there is no room under the damn body. about 3mm to short. so back to the drawing board and order a new pod and motor and gearing....... :angry-tappingfoot: :angry-tappingfoot: :angry-tappingfoot: :angry-tappingfoot: :angry-tappingfoot: :angry-tappingfoot: :angry-tappingfoot:

[wanabgts]

I am trying to get everyone updated over on the new forum.

For the sake of making this run smoothly, from here on out I will be focusing on updates and such over on the new forum. Before too long we won't be able to make new postings in here.

Lets get migrated and get the conversation going on over there!

Zack

[Mseitz]

HI, Having trouble posting on the new site so I'm replying here. I'm listed as having requested #6 for a GT350 but I really asked for #61. If you can correct the typo that would be great. Also, wouldn't that entry be considered a Production Class? I'm not exactly clear on how that was determined.

[wanabgts]

Mseitz wrote:
> HI, Having trouble posting on the new site so I'm replying here. I'm listed
> as having requested #6 for a GT350 but I really asked for #61. If you can
> correct the typo that would be great. Also, wouldn't that entry be
> considered a Production Class? I'm not exactly clear on how that was
> determined.

I got it fixed for you over on the new site. You are all good to go.

Zack