Build Thread for all

Build Thread for all

Postby charlesx@xtra.co.nz » Thu Oct 12, 2017 1:52 am

Hi Dan and all.

With my Touring Car Proxy car completed the Bugeye Sprite is my next project.

Got off to a bad start however. Thought I would use a new 3D chassis I had just got from Aussie but it turned out to be too wide without extensive modification. It is now to be used for an Aston Martin DBR1 project. While preparing for Bugeye use however I prematurely cut off the motor shaft at the opposite end to the usual to fit the 3D chassis. I could therefore not use the BWA motor mount in the usual manner (screwed to the bracket with the provided screw holes) so it was back to the drawing board.

Normally I could just use another motor but with a handout motor provided this was not an option.

This week I have started constructing a brass and piano wire chassis using modified BWA motor mounts and an old brass front axle and guide tongue assembly (probably from 60's) I got in a junk lot of slot car parts a few years ago.

Will add some photos when I figure out how to add on this forum and look forward to others adding their builds.

Regards Chas Le Breton (charlesx)
charlesx@xtra.co.nz
 
Posts: 2
Joined: Tue Aug 29, 2017 2:49 am

Re: Build Thread for all

Postby black3sr » Fri Oct 13, 2017 3:04 am

Chas , Dan has approved buying a replacement motor from SCC. We have bought 2 or 3. We( the three entries from Northlands) are building various chassis. My first one started by using the adjustable plastic chassis from SCC.
black3sr
 
Posts: 7
Joined: Tue Oct 06, 2015 9:20 am


Return to Sprite Proxy Race (SPR) 2018

Who is online

Users browsing this forum: No registered users and 2 guests