BARC/Kleskun Hills Proxy Race

[BARC 1]

That is the whole point of Proxy racing in my opinion. It should motivate and provide a purpose to build and tune a car. I will gladly test your car and pm feedback to you. The 132 guys have been quite helpful to me with respect to my entries in that scale, and I am more then happy to return the favour to those that enter this proxy. Over in the digital proxy, my car's livery appears to be well liked, but it is not finding its way to the podium lol.

Cheers

Dan

[CJR]

Thanks Dan!

[Cjent]

May have to build a car............... Or prepare an older one......... :o

[BARC 1]

That would be great. If you fill an entry form I will have your address so I can send out shipping info to you.

Cheers


Dan

[pfuetze]

the posters for the proxy look great, Dan!
figured out the entry form ;)
i guess adress (postal & paypal) will follow after entry form has been filled out, right?
now i only need to decide which cars to send - as time slipped out of hands (again :( )

[BARC 1]

[pfuetze]

nice video!
got the infos, too!
now - deciding which car to send, do a quick maintence job and send it ...

[taskak]

Finally got my new work bench finished,

two times bigger than old one so there is room for track also.

Also installed new lights and shelves to garage.

Been really busy at work so all this was delayed a lot.

Finally yesterday I set up the track and now I got cars ready for Kleskun Hills .

So I'm in.

[BARC 1]

Great News. Be sure to fill out the entry form. Doing so gets you my address to send the cars to.

Looks like we are going to have a decent turnout for a first event, but until the cars arrive you just never know.

I will post arrival updates when the cars are received.

Cut -off for entries is September 15. So you still have a couple of days to get a car prepared. A stock car with new tires and the magnet removed is about all you need to compete. Guide pins are allowed until they prove to me to be troublesome. IF there are issues with them, I will be sure to post what the issues are and the problems they caused.

Cheers

Dan

[taskak]

Done that and cars are on they way to you

Cheers,

Aki

[pfuetze]

finally finished my cars for the race.
had to change the guides to slideguides, as carrera rails can be higher than the track itself. My guides had been scraping the bottom of slot, so i changed them to SlideGuides.
Wanted to send the Cuda, but could not raise the guide enough.

[BARC 1]

Nice looking cars Peter. It will be fun to run these. Thanks for been part of the inaugural event.

Cheers

Dan

[BARC 1]

[taskak]

[BARC 1]

I have seen those but in the details it says they are die cast. So these are actually plastic bodies.?

The engine detail is great

Cheers

Dan