Home Racing World

I have decided to go as far as I can in this challenge. I will create a new mold using this Monogram body and then use the new resin body for the model itself.



This car has been on that "to do" list. I have done a few GM models, so it's time a FORD joined the ranks.



Here are the basic running gear parts I will use.

Will update with all parts links and begin with body prep. Just showing my choice for now. Figure what better way to close the year out than finally picking my build :clap:

Ya baby!!! Do it up boss man :)

Great body choice for a resin. Should make a great showdown car!

Bob

.........Are those some ball bearings I see in the pile......... :think:

Oh no sir, I don't have a "Gameover Wallet". Just normal bronze Parma oilites. :)

Heck i dont have wise money. I just use brass tube lol.

I have used bearings in the rear of my sportmans entry
square brass tube on the front

very nice body choice Harry
this one should look great

Pardon my not knowing but what is the all scales build off?

Very nice choice... can't wait to see how the resin body comes out!!

Thankyou Crocket...I must be getting dense. I'll look on the desk see what's hiding in the pile. It's time I did something productive and related to my hobbies.
I've been out of circulation since spring when my wife passed, but I'm gonna do something and try harder.

Welcome Back Racie35.

Time to take a deep breath and get your hands and mind into something. I pray for your strength and that you are at peace with your new reality. I look forward to seeing what you decide to come up with. Can't think of much else to say except you are with Friends here.

Cheers

Dan

Thankyou...I just went down and bought some brass...I didn't realize I'm hijacking a thread and I apologize...you can delete it if needed but I have a question..what is the common motor bracket I see used in builds so often and where do you get them..Thankyou.

Thankyou Harry.