by Radarek » Mon Feb 06, 2017 7:07 am
Thx.
Like Dan said those modifications can be done by all and without special tooling. My advice is to do one at the time and check always after one thing is done. That way you want loose tracking. ..
For me the biggest issue was front. Front axle was wobbling a lot so I had to replace holders it others. I could glue them inside the chassis but as I wanted them to be as wide posible I cut little bays ti install holders flat and square with bottom of chassis. What I learn from this step was glue digital pod first as when I cut spot for holder half of the front came loose... any way result is good as there is no friction and unwanted movement on front axle. It works perfectly now.
Other issues was to aligned rear bushings. I used 0.6mm bushing from sloting plus. As they are wider then plastic holders is important to align them perfectly. I used 2.38 mm slot it axle and positioned them as best I could that axle ws going smoothly then do quick test when you have axle sitting into bushings when chassis is on it side axle should slide out from bushings on it own... when all was ready I used ca glue to hold all in place ( make sure all is good as this is one way process ) for final set up I used 2.37 axle any way.
Plastic brace I have added to position motor Ias it is bit shorter then scaley and was loose when installed. Also it helped with making rear rigid.
Off set bushings really help with chassis hight and gear mesh. You can get them in sizes from 0.3mm to 1mm.
Unfortunately I didn't took picture of rear installation
:banana-dance: