Cut and shaped the ladder chassis pieces and gathered other parts.
- .055" piano wire for main rails and front axle uprights
- .064" brass strip for guide tongue and cross members
- 1/8" brass tube for front axle
- 5/32" brass tube for guide post
- JK inline offset motor pod, 3/4" wide
- rear axle oilites, 1/8" x 1/4"
- Cox crown gear for 1/8" axles (27 and 28 tooth to be tried)
- rear aluminum rims (unknown origin) with urethane tires and 1/8" axle
- front RS Slot RSW002 15 x 7 rims with PG tires and 3/32" axle
- resin wheel inserts replicating Cragar five-spokes
Mocked the wheels in position and played with ride height for this desired stance.
Body prep continues and chassis assembly next.
Dan