Cheetah build 2
Posted: Fri Jun 17, 2016 11:30 am
Started on a second Cheetah beginning with a cast from my original Strombecker-bodied car.
Body's just mocked but final stance will be close.
Chassis's my usual small car one using the Devised Designs super slim line motor pod.
Will go with:
Motor - Scalextric FF050 20k red can
Pinion/crown gears - SCX Pro 9t/SCX Pro 27t
Wheels/tires - rear (Slot It F1/homemade March F1 urethanes), front (Slot It 15 x 8 plastic/Slot It low profile)
Wheel inserts - front (Slot It Ford GT40), rear (Slot It Ford GT40 turned down)
Axles - rear (SCX Pro), front (3/32 piano wire)
Curious how it'll run compared to Cheetah 1's different chassis.
Stay tuned.
Dan
Body's just mocked but final stance will be close.
Chassis's my usual small car one using the Devised Designs super slim line motor pod.
Will go with:
Motor - Scalextric FF050 20k red can
Pinion/crown gears - SCX Pro 9t/SCX Pro 27t
Wheels/tires - rear (Slot It F1/homemade March F1 urethanes), front (Slot It 15 x 8 plastic/Slot It low profile)
Wheel inserts - front (Slot It Ford GT40), rear (Slot It Ford GT40 turned down)
Axles - rear (SCX Pro), front (3/32 piano wire)
Curious how it'll run compared to Cheetah 1's different chassis.
Stay tuned.
Dan