PCR for the RSR

[DaveKennedy]

The Scalextric PCR chassis for the RSR Porsche is in stock and likely at dealers now too again in North America. C8543 is the part number.

[noddaz]

Wahoo!

I need that! :lol:

Scott

[DaveKennedy]

They're cheap... so yes you do! :laughing-rolling:

[HomeRacingWorld]

Mine is here!

[chappy]

Got mine too.
Bob

[GRUNZ]

Hey Dave
what is the story with this PCR chassis? Is this new or has been around for a while?
Also, I was under the impression that the PCR chassis would only take inline pods...this seems to take all 3 configurations (which is good in my book).
Are we going to see PCR chassis for more models?

[dw5555]

Slot.it 3D printed PCR underpans are currently available for BMW Z4, BMW E30 M3, Honda Civic, Porsche 911, MG6, Ford Sierra, Mini F56, Volkswagen Passatt and BMW 1 Series.

From the website..

[RvE]

Hi Dave - does the new Scalextric Porsche RSR have a new body compared to say the #86 Gulf Porsche? Its hard to tell from the photos. That new RSR is a great looking car!

Interestingly, I went to LeMans in 2016 and saw the RSR Porsche race, along with the Ford GT. And of course saw the infamous Toyota finish (or lack of finish).

Thanks RvE

[HomeRacingWorld]

The body is the same, just the chassis change sir.

[DaveKennedy]

[DaveKennedy]

[dw5555]

[DaveKennedy]

ok so that makes little sense since the PCR chassis are not made by them we make them and they are in our warehouse not on demand at Shapeways.

[MacMoose]

I am presently racing a Falken-liveried RSR with the PCR chassis. Using a Slot.it sidewinder pod (.5 offset) and a V12/4 23k motor, it's definitely competitive on our track (150 ft routed) against similarly powered GTs. Planning on a long can anglewinder next. Too bad no additional PCR chassis will be offered.

[HomeRacingWorld]

Thanks Moose.

Of all the talk, your the first with a report on your equipped model.