Chassis for Carrera Stang
22 posts
• Page 2 of 2 • 1, 2
Re: Chassis for Carrera Stang
by Brumos RSR » Fri Mar 17, 2017 9:33 pm
Can I mount the carrera chip without a lot of effort
- Brumos RSR
- HRW SlotCar Veteran!
- Posts: 1117
- Joined: Sun Aug 03, 2014 2:58 pm
Re: Chassis for Carrera Stang
by Changing-Gearz » Sat Mar 18, 2017 8:55 am
- Changing-Gearz
- HRW SlotCar Veteran!
- Posts: 217
- Joined: Mon Mar 04, 2013 2:09 pm
- Location: West Newbury, MA
Re: Chassis for Carrera Stang
by Nor Cal Mike » Sat Mar 18, 2017 12:48 pm
-
Nor Cal Mike - HRW SlotCar Veteran!
- Posts: 1270
- Joined: Wed Sep 05, 2012 2:15 pm
Re: Chassis for Carrera Stang
by nhdungeonracer » Sat Mar 18, 2017 2:31 pm
-
nhdungeonracer - SCC Mechanic
- Posts: 1776
- Joined: Tue Sep 04, 2012 7:00 am
Re: Chassis for Carrera Stang
by nhdungeonracer » Sat Mar 18, 2017 2:33 pm
-
nhdungeonracer - SCC Mechanic
- Posts: 1776
- Joined: Tue Sep 04, 2012 7:00 am
Re: Chassis for Carrera Stang
by Nor Cal Mike » Sat Mar 18, 2017 6:15 pm
I don't know what D3D is so it couldn't have been that. I have the pod installed into a Carrera McLaren M20 but I don't have the original car or chassis anymore so I have no way of knowing. The pod has no markings It is the same length and width of the Slot.it inline pod with the exception that it doesn't have the sidewinder blank out wing on the side. As said before, it uses common snap in bushings. The mounting screw layout is the same as Slot.it too.
-
Nor Cal Mike - HRW SlotCar Veteran!
- Posts: 1270
- Joined: Wed Sep 05, 2012 2:15 pm
Re: Chassis for Carrera Stang
by Nor Cal Mike » Sun Mar 26, 2017 1:18 pm
-
Nor Cal Mike - HRW SlotCar Veteran!
- Posts: 1270
- Joined: Wed Sep 05, 2012 2:15 pm
22 posts
• Page 2 of 2 • 1, 2
Who is online
Users browsing this forum: No registered users and 8 guests
Powered by phpBB® Forum Software © phpBB Group