RMS '70 Maverick Trans Am Proxy 2014 - Car Builds & Such

[SRQSloter]

Track width. Tires not to exceed width of body when viewed from above.

[SRQSloter]

Motor configuration?

[SRQSloter]

Ok was just wondering. I'll do a inline also. And one other thing then I'll leave you alone. :lol: How are you thinking of doing the scoring as far as lap counting goes? Full laps plus partial laps in feet.


:text-thankyouyellow:

[HomeRacingWorld]

I am pretty sure it is HRW specific sir. We try to keep the proxys we start here HRW only.

I guess I need to finish mine then.

[TuscoTodd]

Count me "In like Flynn!" :D
Now to see if I can't talk a couple non-board member, racing partners and friends into getting in on this as well! :D

[ListerStormGT]

Darn you Jeremy! :mad: :lol: Oh just go ahead and add me to the list too. Not only did you give me a reason to get one of these from Dave now, you also gave me a reason to build a chassis. This should be fun!

[SRQSloter]

8-) 7 entries already. And the first of April sounds good.

[turbokev]

Sign me up to send a car and to host a race..
Just placed my order with David~

Put me later in the schedule to host please..
Track is not finished.. but will be.
Table is framed, mdf is in the garage.. getting ready to start routing this week.

Will be a 16 x 7 routed road course running at 10 volts.. PM controllers.

Hey, question on the wheels and tires.. You list one tire, but different size front and rear wheels..

Please clarify ? Are we to put whatever we want on the front 15x7 wheels? or run the spec tire on all 4 wheels even though the are 15x7 and 15x8?

Also, rules say exterior of the body must remain stock as received from RMS Resins.. Can we add a lower air dam like you did? or a trunk lid spoiler?


Thanks, (don't mean to be a pain, just want to make sure I do it right)

[SRQSloter]

So if two cars finish on the same lap but in different heats. But one car goes a half lap farther and has slower fast lap time than the other car with the fast lap gets the win.

[TuscoTodd]

PM inbound with the "tentative" plan... :D

[dreinecke]

I have orders from Shotgun and Kevin thus far. I only ship on Saturdays and will start making a few more up for those involved.

Thanks Jeremy for kicking this off!

[turbokev]

[SRQSloter]

[turbokev]

[TuscoTodd]

Another option that may be a possibility from a "cut / modify" scenario is to start with possibly a WOMP or Sprints Plus chassis - I would think that either could be modified to work fairly easily if you aren't comfortable starting from scratch... :)