PPP (Printed Porsche Proxy) Round 1 - Timberline Trace

[chappyman66]

[FC47]

Good job guys, they look great, good racin!
:banana-dance:

[Aloha]

Thanks guys. Tried to do this with a 3D guide. Real issue would be the rubber tire choice and not locking down the front axle. Fun fun fun!
Aloha
Dale

[JamieB]

Thanks for hosting and also writing up an exciting recap! I didn't have any luck printing a guide, so in a desperate last minute measure I hillbillied together that Scalextric guide. I hope it holds up and doesn't cause the car too many offs.
Thanks again, I look forward to the next round!
Jamie

[chappyman66]

Jamie....the shallow guide was tough, yup. Did you try the flags on Thingiverse? There are a couple (including mine) that should print pretty easily. Mine is actually a little too deep, even for Carrera track.

Dale....I was going to try sending your tires....thoughts?

Thanks for building and sending the cars. On to round 2!

[Aloha]

Try and see
Thank you for the attention
Aloha
Dale

[JamieB]