by Drewbert34 » Thu Apr 26, 2018 7:06 am
A couple of ideas:
1. Outlet plugs are available with motion detection. There's bound to be a way for you to cut your track on/off by cutting power while leaving the switch in the on position. I do this now, but have tied my Carrera room into my whole home automation. I walk in the room, everything cuts on.
...for track calls
2. Open the C.U. and solder wires to 2 of the 8 joints where the start button is connected to the board. As long as you use 1 up / 1 down, it won't matter which 2 of the 8 you select. Run those wires to a 3.5mm mono female recepticle and mount inside your CU so that you can plug in a 3.5mm male splitter. From there, connect whatever momentary switches you choose.