by Nor Cal Mike » Tue Mar 17, 2015 7:11 am
When I shorten or lengthen these chassis, I typically do it as a one off. This means I am juggling two or three pieces of wood, brass & clamps at one time while praying that I get everything lined up OK, the wheelbase right and not twisted like a pretzel. This jig takes care of 99% of that. I am doing a lot of Revogram Grand Sport chassis too for my front motor series. I think a similar jig but with a deeper dropped section down the center will work for them too.
Last edited by
Nor Cal Mike on Tue Mar 17, 2015 8:41 am, edited 1 time in total.