Taping Question

Got Wood?
Your ROUTED TRACK Home!
Share Your Designs, Building Techniques & Finished Layouts!

Taping Question

Postby scatman » Wed Nov 13, 2013 6:44 pm

Does it matter what the temp should be when taping? My past experience has always been warm. It's a cold night, but the garage is cool. Around 70 degrees.
User avatar
scatman
HRW SlotCar Veteran!
 
Posts: 570
Joined: Sun Feb 03, 2013 2:51 pm
Location: South MS.

Re: Taping Question

Postby HomeRacingWorld » Wed Nov 13, 2013 7:36 pm

Sounds fine to me. 70 is just right.
User avatar
HomeRacingWorld
HRW Janitor
 
Posts: 15569
Joined: Wed Aug 08, 2012 2:05 pm
Location: HRW Skunkworks

Re: Taping Question

Postby MoparGreg » Wed Nov 13, 2013 7:56 pm

In my opinion it should no really matter what the temp is. Just use a good quality tape like venture.
User avatar
MoparGreg
HRW SlotCar Veteran!
 
Posts: 757
Joined: Tue Sep 04, 2012 10:00 pm
Location: Australia

Re: Taping Question

Postby scatman » Wed Nov 13, 2013 8:33 pm

Thanks guys. I'm going start tomorrow. Was planning on starting tonight, but I'm tired.
User avatar
scatman
HRW SlotCar Veteran!
 
Posts: 570
Joined: Sun Feb 03, 2013 2:51 pm
Location: South MS.

Re: Taping Question

Postby waaytoomuchintothis » Wed Nov 13, 2013 8:53 pm

Just remember the tape has sharp edges. As many times as I have taped glass, slot car tracks, all kinds of stuff, I always forget, and today sure enough, I sliced my ring finger on my right hand, just like I always do. I'll be taping again tomorrow. Only 300 feet to go!
User avatar
waaytoomuchintothis
"Seasoned SlotRacer"
 
Posts: 7576
Joined: Wed Aug 29, 2012 7:16 pm
Location: Chesterfield, Virginia

Re: Taping Question

Postby RichD » Thu Nov 14, 2013 7:23 am

Do not put any tension on the tape as you lay it down, if you do it may split later, especially if it crosses a joint. We have tracks that developed a lot of splits over the years and others that did not, they all used Venture tape.
User avatar
RichD
HRW SlotCar Veteran!
 
Posts: 1885
Joined: Thu Sep 06, 2012 7:41 am
Location: East Haven, CT


Return to The Lumber Yard



Who is online

Users browsing this forum: No registered users and 12 guests

cron