Page 1 of 2

Oldsmobile Omega "Finished!"

PostPosted: Mon Dec 11, 2017 10:33 pm
by dge467
You never know what you can find at automobile swap meets. I found this last October. The man selling it told me it was left over stock from his sisters store that closed in the 1980's. I picked it up for $12.00 still sealed.

I am going to build it as a Trans Am type racer. The chassis and interior are from a Scalextric 69 Camaro that had a very banged up body. Stay tuned.

Image

Re: Oldsmobile Omega

PostPosted: Tue Dec 12, 2017 12:52 am
by Wobble
Hot ... hot ... hot

Re: Oldsmobile Omega

PostPosted: Tue Dec 12, 2017 6:30 am
by HomeRacingWorld
Yes sir it is. Nice find.

Re: Oldsmobile Omega

PostPosted: Tue Dec 12, 2017 7:21 am
by Dundee Denny
My kind of build!!!!!

Dundee Denny

Re: Oldsmobile Omega

PostPosted: Tue Dec 12, 2017 11:18 am
by waaytoomuchintothis
For realistic detail, you can have the entire rear section rust off onto the ground in a heap! I always wondered if they got the steel for that one from Lancia.

Re: Oldsmobile Omega

PostPosted: Tue Dec 12, 2017 2:28 pm
by Audi1
Looks like this is going to be another nice build from Jeff!

Allan

Re: Oldsmobile Omega

PostPosted: Tue Dec 12, 2017 3:12 pm
by Gameover
i need to find this kit!

Re: Oldsmobile Omega

PostPosted: Tue Dec 12, 2017 9:50 pm
by Wobble
They've reintroduced the Falcon/ Futura ute/ pickup and the Avanti so fingers crossed this one will pop up again (if it's by the same manufacturer).

Re: Oldsmobile Omega

PostPosted: Tue Dec 12, 2017 10:11 pm
by dge467
Sorry, I forgot to mention the manufacture of the kit! It is by Lindberg. The box is dated 1976.

Re: Oldsmobile Omega

PostPosted: Wed Dec 13, 2017 9:07 am
by red73mustang
I was reluctant to even look at this, but it actually looks kind of "racy"!

Re: Oldsmobile Omega

PostPosted: Wed Dec 13, 2017 9:14 pm
by Broman62
I like the looks of it!!

Re: Oldsmobile Omega

PostPosted: Sun Dec 17, 2017 9:19 pm
by dge467
Well it is finished! I ended up painting the body with Tamiya Light blue and clear coat. The rear spoiler is from a Scalextric 69 Camaro junker. The front spoiler is from a 1/25 scale kit. It was in my spare parts box. I just trimmed it an filed it down some to fit. The fuel fillers are from that same Camaro. I used chrome foil on the trim.

The interior tub was trimmed a bit on the bottom, the top of the dash board was trimmed down too. I also made the roll cage more upright, as it was a bit too laid back. A filler piece was made at the rear of the interior tub to fit the body contour better.

I soaked the wheels in rubbing alcohol to strip off the yellow paint, and just left them in the white bare plastic color. I added some random decals too. Not a bad kit, except for the two sink marks in the radiator grille.

It make a cool and different slot car for sure!

Image

Image

Image

Image

Image

Image

Image

Re: Oldsmobile Omega "Finished!"

PostPosted: Sun Dec 17, 2017 9:32 pm
by HomeRacingWorld
Cool is right. You did another great job with this one.

Re: Oldsmobile Omega "Finished!"

PostPosted: Sun Dec 17, 2017 10:37 pm
by waaytoomuchintothis
Looks great. The real car never looked so sharp!

Re: Oldsmobile Omega "Finished!"

PostPosted: Sun Dec 17, 2017 11:54 pm
by dreinecke
Nice ride Sir! Looks very smooth.

Maybe it is time these made a comeback...Image

Image

Image