Making Nerf bars???

[Quickcars]

Pardon my complete ignorance on anything to do with welding, but how the heck do you fabricate nerf bars without burning your fingertips off. I cut up some pieces of pretinned copper wire to make a set of nerf bars and I just kept staring at them trying to figure out how to actually accomplish the task.

Well, after several very clumsy attempts with no success, I figured I'd better ask before I accidently branded myself! :angry-cussingblack:

QC

[Quickcars]

You are such a goof!!! :lol: :lol: :lol: :lol: :lol: That's a good one!

Now seriously, I need some help here. You wouldn't want me to hurt myself....wuud ya?

[mokid]

I use algator clip you may find something in that nature

[Dangermouse]

try these


DM

[HomeRacingWorld]

The gator clips are priceless :)

[waaytoomuchintothis]

Oh, I thought we were talking about the places Jenny goes to, to drink.

[DAVE]

Old timey mag wheel balancing weights work well to hold the pieces in place while soldering them together.

[Cheater]

Beside's roach clip's try taping the parts to a flat surface,then solder.

Cheater

[Kemtronracer]

I use a small flat blade screwdriver with a notch cut in the tip. It holds those round parts nice and tight, exactly where I want them, until the solder cools down. Just don't solder the screwdriver to the chassis..